Procedures For Through-Beam Sensor Heads; Positioning And Setting Threshold Values; Setting Various Functions - Omron ZX Series Operation Manual

Procedures for Through-beam Sensor Heads

2-4 Procedures for Through-beam Sensor
Heads
2-4-1

Positioning and Setting Threshold Values

Manual Setting
Automatic Setting
l Workpiece surface positioning:
l Unknown size workpiece judgement:
l Judging workpiece with uneven surfaces, warped workpieces, or mov-
ing workpieces:
2-4-2

Setting Various Functions

l Changing the incident level to any value:
l Changing the display value:
l Changing the response speed or increasing resolution:
l Changing positioning accuracy when operating and releasing:
l Holding value during measurement:
l Using OFF-delay timer:
l Operation requiring two Sensor Heads.
l Resetting default status:
24
3-7-2 Inputting Threshold Values Directly
Position Teaching in 3-7-1 Teaching
Two-point Teaching in 3-7-1 Teaching
Automatic Teaching in 3-7-1 Teaching
3-8-1 Auto-scaling
3-8-2 Scaling
3-8-3 Number of Samples to Average
3-8-4 Hysteresis Setting
3-8-5 Hold Functions
3-8-6 Timer
3-8-7 Two-sensor Operation
3-8-8 Initializing Settings
Section 2-4