Table of Contents
Advertisement
APPENDICES
A. MAIN DISPLAY PARAMETERS
The parameters and their meanings are detailed as follows: -
FUEL:
The selected fuel will be displayed, i.e. PETROL.
• PETROL – Leaded or Unleaded petrol/gasoline.
• LPG – Liquid Petroleum Gas
• CNG – Compressed Natural Gas
• DIESEL
DATE :
Analyzer date. See Set-Up menu to change.
TIME :
Analyzer time. Use Set-Up menu to change.
BATTERY : Displays the battery level from 0-100%. During normal data
display operation the analyzer will show LOW BATTERY briefly at
intervals of about 45 seconds for less than 30% of charge. The
analyzer will turn off if less than 10% charge is detected. With the
charger connected the display will read close to 100%.
Note: Allowing the battery to discharge fully may destroy it.
O2 :
Oxygen measured in the exhaust gas indicated in percentage %.
With the pump off the analyzer will display - - - -. If there is a fault
with the oxygen sensor then FLT will be displayed.
CO :
Carbon monoxide measured in the exhaust gas indicated in
percentage %. With the pump off the analyzer will display - - - -. If
there is a fault with the CO reading then FLT will be displayed.
CO2 :
Carbon dioxide measured in the exhaust gas in percentage %.
With the pump off the analyzer will display - - - -. If there is a fault
with the CO
HC :
Hydrocarbons measured in the exhaust gas indicated in ppm
(parts per million) n-hexane (petrol). With the pump off the
analyzer will display - - - -. If there is a fault with the HC reading
then FLT will be displayed.
reading then FLT will be displayed.
2
AUTOplus manual
Page 40
Hide quick links:
Advertisement
Table of Contents
