Lan - New Rock Technologies NRP1004 Series User Manual

NRP1004 Series IP Phone
Name
DHCP
PPPoE
802.1x Settings
User
Password
Enable 802.1x
After parameter setting, click Apply to validate these parameters.

If you change the IP address, you need to input a new IP address in the address bar so that you

can log in to the phone.
If you use an IP address obtained during the system startup, and the IP address of the DHCP

server is identical with the LAN IP address, the system increases the last octet of the LAN IP
address by 1 and modifies the LAN IP address segment assigned by the DHCP server. If the
system attempts to accesses DHCP services after startup, and the IP address assigned by the
DHCP server is identical with the LAN IP address, the WAN port cannot obtain an IP address
and therefore the phone cannot access the network through the WAN port.

5.4.2 LAN

Figure 5-10 LAN setting interface
Table 5-8 LAN parameters setting
Name
IP Address
Subnet Mask
New Rock Technologies, Inc.
Description
Indicates whether to enable the DHCP mode. If you choose this mode, the phone can
obtain the network-related information automatically from the DHCP server
automatically, and no action is required.
Indicates whether to enable PPPoE mode. If you choose this mode, you need to input
the ADSL account and password.
Description
Specifies a static LAN IP address.
Specifies a LAN subnet mask.
User Manual
5-9