New Rock Technologies NRP1004 Series User Manual page 65

NRP1004 Series IP Phone
Figure 5-21 Dial plan setting interface
Table 5-20 Dial plan parameters setting
Name
Basic Setting
Press "#" to Send
Dial Fixed Length
Press # to Do
Blind Transfer
Blind Transfer on
OnHook
Attend Transfer
on OnHook
New Rock Technologies, Inc.
Description
Indicates that you need to press # after dialing a number.
Indicates that the phone will automatically call out after the number with a specified
length is dialed. For example, if the value is set to 11,
Enables the phone to transfer the incoming call to a specified number (the third party)
after # is pressed. This function requires you to press # after inputting the phone
number of the third party.
Enables the phone to transfer the incoming call to a specific number (the third party)
after hang-up. This function requires you to input the number of the third-party before
hang-up.
Enables the phone to transfer the incoming call to a third party after the call is
answered.
User Manual
5-35