Table of Contents
Advertisement
February 2009
Entering Digital Outputs
(cont.)
1-24
2. The next prompt asks you to select the data source for the digital
output. The choices vary with the function. For Pulse Totalizer
(see Figure 1-24 on page 1-23), the available choices include:
•
Forward Totalizer
•
Reverse Totalizer
•
Standard Forward Totalizer
•
Standard Reverse Totalizer
a. Press
[ENTER]
to open the data source selection window.
b. Scroll to the desired source.
c. Press
[SEL]
to confirm your selection.
d. The prompt then moves to a list of unit types. (The available
units depend on the selection made at the Data Source prompt.)
Scroll to the desired output unit.
e. Press
[F3]
(OK) to confirm your selection.
3. The last set of parameters that appears depends on the selection
you made at the Function prompt.
Pulse Totalizer
If you selected
The prompt asks for the units/pulse and the pulse width (in
microseconds). (Figure 1-24 on page 1-23 illustrates a Digital Output
window configured for the Pulse Totalizer function.) For the Units/
Pulse and Pulse Width parameters:
a. Press
[ENTER]
to open the text box.
b. Use the numeric keys to enter the desired value.
c. Press
[ENTER]
to confirm your selection.
Frequency
If you selected
The prompt asks for the minimum and maximum value for the
category and units selected and the minimum and maximum
frequency. For each parameter:
a. Press
[ENTER]
to open the text box.
b. Use the numeric keys to enter the desired value.
c. Press
[ENTER]
to confirm your selection.
:
:
Programming Site Data
Advertisement
Table of Contents
