Entering The Transducer Parameters - GE Transport PT878 Abridged Manual

August 2008
Entering the Program
Menu (cont.)
Entering the Transducer
Parameters
2-2
When entering information in an option window, press:
•
the [ ] key to scroll down the list
•
the [ ] key to scroll up the list
•
the key (Cancel) or the
[F2]
and return to Operate Mode without changing the data.
Note: If you enter an incorrect numeric value, press the [ ] key to
erase the last digit entered.
To program the Transducer data, scroll to the Transducer option on
the Program Menu and press
Note: Refer to your Transducer Installation Guide for additional
information about transducers and configurations.
.
Transducer/Pipe
Transducer
Pipe
Type: Wetted
Transducer
Frequency 2.00
Wedge Ang
Wedge Tmp
Wedge SS
Figure 2-2: The Transducer Option Window
1. At the Type prompt, use the [ ] and [ ] keys to select the type of
transducer used in your installation (wetted or clamp-on). Press
to confirm the choice.
[ENTER]
Note: Each choice made in the Transducer and Pipe menus will
determine the additional options that must be programmed.
key to close a window at any time
[ESC]
(see Figure 2-2 below).
[ENTER]
Lining Fluid Path
Clamp-on
Special
Tw
MHz 14
°
50
°C
25
m/s
1219.2
Cancel
OK
µs
Initial Setup