Troubleshooting - Maxx Ice MIM50-0 Instruction Manual

TROUBLESHOOTING

Before Calling for Service
If the unit appears to be malfunctioning, read through the OPERATION section of this
manual first. If the problem persists, check the Troubleshooting Guide below and on
the following page. The problem could be something very simple that can be solved
without a service call.
Problem
The machine
does not operate.
The water doesn't feed in
after the machine starts.
Machine makes ice, but ice
storage bin does not fill up
with ice.
Water is leaking from the unit.
Possible Cause
The icemaker is unplugged.
The fuse is blown.
The Power switch is set at
OFF.
The ice storage bin is full of
ice.
The water supply tap is turned
off.
The water supply line is not
properly connected.
Condenser may be dirty.
The air flow to the ice maker
may be obstructed.
The ambient temperature
and water temperature are
high, or machine is near
some heat source.
A few water drops fall to the
floor when you open the door
to take out ice from storage
bin.
Water supply connection
leaking.
Probable Correction
Plug the ice maker in.
Replace fuse – if this hap-
pens, call for service to
check for a short circuit in the
ice maker.
Turn the Power switch to ON.
Remove some ice, making
sure the ice-full probe is free
of ice.
Turn on the water supply tap.
Reconnect the water supply
line.
Clean the condenser.
Check the installation.
Check the installation.
Normal condensation on the
door or some water together
with ice. Take care when you
take out ice.
Tighten fitting. See "Connect-
ing the Water Line".
18