Table of Contents
Advertisement
TROUBLESHOOTING
Problem
Cubes are partially formed or
are white at the bottom.
Noise during
operation
The ice maker stops suddenly
while making ice.
The body of the ice maker is
electrified.
Scaling occurs
frequently inside
the machine.
Water leaks from the ice stor-
age bin.
19
Possible Cause
Not enough water in the water
trough..
The legs are not leveled and
locked.
Certain sounds are normal.
The electricity is off.
The room temperature is out
of the stated range.
The ice storage bin is full of
ice.
The ground line isn't in the
socket.
The water is too hard.
The drain hole below the ice
storage bin is blocked.
The drain hose is kinked or
improperly placed higher
than the floor of the ice stor-
age bin.
Probable Correction
Check if the water supply
pressure is below 15 psig.
Check water supply; filter
may be restricted.
Check for a water leak at the
water trough..
Level and lock the feet. See
"Leveling the Ice Maker".
See "Normal Sounds".
Reconnect the power supply
line.
Cut off the electricity; let the
ice maker stop working until
the temperature returns to
within the stated range.
Remove some ice; be sure
ice-full probe is free of ice.
Use a socket meeting the re-
quired electrical standard.
Using a water-softening de-
vice installed in front of the
water inlet.
Pull out the ice storage bin
and clean the drain hole.
Check the drain hose to
make sure the water can
drain out unhindered.
Advertisement
Table of Contents
