Maxx Ice MIM50-0 Instruction Manual page 10

Automatic outdoor ice maker
Table of Contents

Advertisement

To replace door on hinges:
1. Using a flat screwdriver, remove the plug buttons from the screw holes opposite
the door hinges, top and bottom. Set aside.
2. Remove the bottom hinge and place it on the opposite side at the bottom of the
door.
3. Position the door on the bottom hinge.
4. Align the door on the bottom hinge and replace the top hinge and top hinge
mat.
5. Replace top hinge cover.
6. Push the plug buttons into the original screw holes.
Water Supply
The water supply should be ready at the point of installation. The water supply pres-
sure should be a minimum of 15 psig with a static pressure not more than 80 psig. (A
wall outlet directly behind the ice machine will make installation easier.)
IMPORTANT:
All installations must be in accordance with local
plumbing code requirements. Professional installation is
recommended.
Make certain that the hoses are not pinched or
kinked or damaged during installation.
Check for leaks after connection.
Tools required: 1/2" open-end wrenches,
Phillips screwdriver
Connecting the water line:
1. Turn off main water supply. Turn on the nearest faucet long enough to clear the
line of water.
2. Find a 1/2" to 3/4" vertical cold water pipe near the installation location. The dis-
tance should be less than 9 feet. The water supply hose provided with the ice maker
is about 9 feet.
3. A shut-off valve must be installed to the main water supply. If the water pipe has a
plain piece of copper tubing, attach a 1/4" O.D. compression union to the tubing
and remove the nut.
4. Connect nuts of water supply hose to the tap, and connect the other end with the
water inlet. Tighten firmly by hand, then one-half turn with wrench.
5. Turn on main water supply and tap. Check for water supply connections leaks.
Tighten every connection (including connections at the water inlet).
When you connect the water supply hose and the drain hose, pay attention to the
indications of "Water inlet" and "Drain outlet" on the machine.
9
Rear of unit
Water inlet
Drain outlet

Advertisement

Table of Contents
loading

Table of Contents