Operation - Maxx Ice MIM50-0 Instruction Manual

Built-in Installation:
If this method of installation is chosen, it will still be necessary to allow adequate venti-
lation space around the unit. The following additional items must be observed.
1. Place ice maker in front of installation location. Remove the legs and place the
unit flat on the floor or on a platform depending on your installation requirements.
2. The water supply line must be plumbed before connecting to the ice maker.
3. Connect the drain hose.
4. Turn on main water supply and tap. Check for water supply connection leaks.
Tighten every connection (including connections at the water inlet).
5. If the electrical outlet for the ice maker is behind the cabinet, plug in the ice
maker.
6. Push the ice maker into position.
7. Seal all around the cabinet to the floor with an approved caulking compound.

OPERATION:

Final Check List before Operation
1. Have all packing materials and tape been removed from the interior and exterior
of the ice maker?
2. Did you clean the ice storage bin?
3. Have the installation instructions been followed, including connecting the machine
to water, drain and electricity?
4. Has the machine been leveled?
5. Is the ice maker in a site where the ambient temperature is between 45°F (7°C)
and 110°F (43°C) and the water temperature within 41°F (5°C) and 90°F (32°C) all
year round?
6. Has the water supply pressure been checked to ensure a minimum of 15 psig with
a static pressure not to exceed 80 psig?
7. Is there a clearance of at least 2/5 at the rear, and 1" at the top and 1⁄5 at the
sides for proper air circulation?
8. Has the power supply voltage been checked or tested against the nameplate rat-
ing? And has proper grounding been installed for the ice maker?
9. Is the ice maker plugged in?
10. Have you turned on the main water supply and the tap?
11. Have you checked for leaks at all water supply connections?
Operating Method
1. Turn on the water tap and let the water trough fill. Then set the Power switch on
the front panel to the ON position. The ice maker will start working automatically.
11