Maxx Ice MIM50-0 Instruction Manual page 9

INSTALLATION
Leveling the Ice Maker
It is important for the ice maker to
be leveled in order to work properly;
otherwise water will not flow as it
should through the evaporator (ice
mold). Ice production will be less
than normal, and operation will be
noisy. The ice maker can be raised
or lowered by four leveling legs on
the bottom of the machine. If you
find that the surface is not level. You
may need to make several adjust-
ments to level the machine. We rec-
ommend using a carpenter's level
to check it.
1. Place a carpenter's level on top of the product to see if the ice maker is level
from front to back and side to side.
2. Adjust the height of the legs as follows:
Turn the leveling legs to the right to lower that side of the ice maker.
Turn the leveling legs to the left to raise that side of the ice maker.
IMPORTANT: Once you are ready to install it in a cabinet or directly on the floor, you
must adjust the legs to level the ice maker.
Reversing the Door Swing
TOOLS NEEDED: Flat screwdriver, Phillips screwdriver
IMPORTANT: Before you begin, unplug the ice maker or disconnect power.
To remove door from hinges:
1. Remove the top hinge
cover.
2. Using a Phillips screwdriver,
remove the screws, then remove
top hinge mat and top hinge.
Keep the parts together and set
them aside.
3. Lift the door off of the bot-
tom hinge and turn it upside
down so that the handle is on
the right. Set the door aside.
8