AJAX CombiProtect User Manual page 7

Alarm LED indication
Motion Detector
Motion Detector Sensitivity
Motion Detector Always Active
Glass Detector Enabled
Glass Protection Sensitivity
Glass Protection Always Active
Alert with a siren if motion detected
Alert with a siren if glass break detected
Jeweller Signal Strength Test
Detection Zone Test
armed mode when using night mode
Allows you to disable the flashing of the LED
indicator during an alarm. Available for devices
with firmware version 5.55.0.0 or higher
If active, motion detector will be active
Choosing the sensitivity level of the motion
detector:
High
Normal
Low
If active, the detector always registers motion
If active, glass breaking detector will be active
Choosing the sensitivity level of the glass
detector:
High
Normal
Low
If active, the detector always registers glass
breaking
If active, added to the system are
activated when the motion detected
If active, added to the system are
activated when the glass break detected
Switches the detector to the signal strength test
mode
Switches the detector to the detection area test