SMC Networks SMCD3GNV User Manual page 181

If...
The Power and other LEDs are OFF.
The DS and US LEDs are OFF.
The WiFI LED is OFF.
Check the Gateway's telephone interfaces
To confirm that the Gateway's two telephone interfaces are working properly:
1. Lift the handset of the device connected to the Gateway's telephone 1 interface, Confirm
that the Tel LED goes ON. Hang up the device (place the device onhook) and confirm that
1
the Tel LED goes OFF.
1
2. Lift the handset of the device connected to the Gateway's telephone 2 interface, Confirm
that the Tel LED goes ON. Hang up the device (place the device onhook) and confirm that
2
the Tel LED goes OFF.
2
Troubleshooting Procedures
Table 54. Checking Basic Gateway Functions
1. Turn off the Gateway and then turn it on again to see whether the problem is
resolved.
2. Check that you are using the power adapter supplied with the Gateway.
3. Be sure the power cord is connected to the Gateway and to a functioning power
outlet.
4. Plug a working device, such as a lamp, into the power outlet to confirm that the
outlet is working.
5. Be sure the power outlet is not controlled by a wall switch that can inadvertently
remove power from the outlet
1. Be sure the Ethernet cable connections are secure at the Gateway and at the
computer.
2. Be sure that power is turned on to the computer connected to the Gateway.
3. Be sure you are using the Ethernet cable supplied with the Gateway or one
configured similarly to it.
See "Checking the Gateway's Wireless Connection" on page 198.
SMCD3GNV Wireless Cable Modem Gateway User Manual
Perform This Procedure
181