Remote Management - SMC Networks SMCD3GNV User Manual

Disabling Port Triggering
You can disable individual or all port-triggering rules from the Port Triggering menu.
To disable an individual port-triggering rule, uncheck the rule in the Active column.

Although disabled, you can still use the buttons to the right of the checkbox to edit or
delete the rule. To enable the rule, check the checkbox in the Active column.
To disable all port-triggering rules, click Disabled next to Enable Port Triggering. The

ADD PORT TRIGGER button becomes unavailable and all port triggering rules turn gray
to show they are disabled. In addition, the buttons to the right of the checkboxes become
gray, preventing you from editing or deleting port-triggering rules. To enable all port-
triggering rules, click Enabled next to Enable Port Triggering.

Remote Management

The Gateway supports centralized administration and management via the following
methods:
HTTP

HTTPS

Telnet

SSH

SNMP

HNAP

Using the Remote Management menu, you can independently enable or disable these
remote management methods. The Remote Management menu also lets you provide
remote access to a single computer, a group of computers that fall within a particular range
of IP addresses, or any computer.
To display the Remote Management menu, click Advanced > Remote Management in the
menu bar. Figure 96 shows an example of this menu and Table 48 describes the settings.
Configuring the Gateway's mso Interface
SMCD3GNV Wireless Cable Modem Gateway User Manual
163