Taking Measurements Using The Watchbp Office Vascular; Turn On The Power; Connect The Cuff(S) To The Device; Select The Measurement Arm(S) And Ankle - Microlife WatchBP Office Vascular Instruction Manual

Taking measurements using the
WatchBP Office Vascular

Turn on the power

Turn on the device by pressing the

Connect the cuff(s) to the device

Connect the cuffs to the device by inserting the cuff connector into the cuff connector
socket.

Select the measurement arm(s) and ankle

You may select the arms and ankle(s) for the measurement by pressing the
button to scroll among the arm(s) and ankle(s) for taking the measurement.
Press the
You may select one arm, both arms (for assessing inter-arm difference) or one arm and
one leg (for ABI /baPWV assessment).
button to switch between each Mode.
Press the
Settings of the measurement
Part A) For measurement of one arm or simultaneous both arms
The measurement program of the device can be set when the measurement of one
arm or both arms is selected, including Number of Measurements, Resting Time
(Countdown Time), Interval Time, AFIB Detector, CBP Measurement, and
Average Calculation (Discard 1st measurement or not)
This can be done as follows:
1 Set the Number of Measurements – Press the
first enter setting of Number of Measurements. Use the
button to scroll up and use
to six measurements. Press
of measurements and enter Resting Time setting.
2 Set the Resting (or countdown) Time – Press the
to scroll up and use
60, 120, 180, 240, 300 seconds of Resting Time. Press
button to confirm and enter Interval Time setting.
button of the device.
button to scroll down between one
button to confirm the number
button to scroll down between 15, 30,
WatchBP Office
button to
button
button.
11
EN