Table of Contents
Advertisement
If Contact ID messages are received from the panel, the e-mail will be sent as:
From: T-Link 123456
To: recipient@address.com
Subject: T-Link v1.2.xx; 123456 Event Report
Message: 6789s1s100s01ss001sMedical
NOTE: The text length will have a maximum number of characters that will be equal to the longest Contact
ID message. A space will be inserted for every "s" above.
[028] E-mail From
The 'E-mail from' option is used for the 'FROM' field in E-mails sent out by the TL250/TL300.
If the option is not programmed (all 0's) then the 'from' field of the TL250/TL300 will look as
follows:
T-Link AAAAAA where A is the account code of that TL250/TL300. If this option is pro-
grammed with any string, the value in the 'FROM' field will be programmed in this option.
[029] DNS Server Address
Default: 000.000.000.000
In order to communicate to a T-Link TL250/TL300 via a host name, program the IP address of
the DNS server. The DNS lookup for the TL250/TL300 will only work for TL250/TL300 with
Static IP addresses (Dynamic DNS is not supported).
[030] SMTP Server Name (64 characters max.)
Default: None
In order to send E-mails to the Internet a valid outgoing E-mail server. Contact your Internet ser-
vice provider or system administrator for this information. This option can only be programmed
with T-Link Console software.
[031] E-mail Account (64 characters max.)
Default: None
Some E-mail servers will require an account name to allow outgoing messages to be sent. Con-
tact your Internet service provider or system administrator for this information.
NOTE: This option can only be programmed with T-Link Console software.
[032] E-mail Account Password (20 characters max.)
Default: None
Some E-mail servers will require a password and the account name to allow outgoing messages
to be sent. Contact your Internet service provider or system administrator for this information.
NOTE: This option can only be programmed with T-Link Console software.
[033] Trouble Toggle Option Section 1
Option [033] and [034] are for the trouble reporting toggles. To enable, set the specific trouble
toggle option ON. To disable, set toggle to option OFF.
Toggle
[1]
[2]
[3]
[4]
[5]
[6]
[7]
[8]
NOTE:*Must be ON for UL/ULC installations
Default
ON
| _ ___________|
ON
| _ ___________|
ON
| _ ___________|
ON
| _ ___________|
OFF
| _ ___________|
*OFF
| _ ___________|
*OFF
| _ ___________|
*OFF
| _ ___________|
Description
Network Trouble
Invalid Account (set as FFFFFF)
Receiver 1 Absent
Panel Communication Trouble
Input Alarm
FTC to Receiver 1
PC5108 Absent
PC5108 Tamper
19
Advertisement
Table of Contents
