Operating Instructions; Check Connection; Searching For The Device - urmet domus 1099 User Manual

5

OPERATING INSTRUCTIONS

5.1

CHECK CONNECTION

The factory default IP address for the IP camera is 192.168.1.168 and the subnet mask is 255.255.255.0. Give your
•
computer an IP address in the same network segment as the IP camera, for example, 192.168.1.69, and the same
subnet mask as that of the IP camera.
Check whether the IP camera is connected and switches on properly by selecting Start > Run, entering "cmd" and
•
pressing ENTER; then enter "ping 192.168.1.168" in the command line window.
Check whether the IP camera is accessible. If the PING command is executed successfully, it means that the IP
•
camera is operating normally and the network is connected properly. If the PING command fails, check the IP
address and gateway settings of the PC, as well as the network connection.
5.2

SEARCHING FOR THE DEVICE

Feedback: The Device Config Tool function may be used to search for the device across network segments. Before
•
running the Device Config Tool, select the local connection icon at the bottom right corner of the desktop;
Add the IP addresses of several network segments in the TCP/IP local area connection settings (as shown below).
•
You can run this tool to search for any device with an IP address in the same network segment.
Note:
Device Config Tool uses the Multicast protocol to search for the device across the segments; however, since firewalls
prevent multicast data packet traffic, they must be disabled so that the information on the device can be acquired.
DS1099-014A 11