Device Connection; Ip Camera Connector Layout (Where Present) - urmet domus 1099 User Manual

4

DEVICE CONNECTION

The IP camera can be connected in two ways:
Connection to a PC
•
Connect the IP camera to the PC using a direct network cable, with the power input connected to a 12VDC
adaptor, and enter the IP addresses of the PC and the camera in a network segment. The IP camera will
communicate with the PC within one minute after being switched on if the network is working properly.
Connection to a router/switch
•
This solution is more commonly used to connect the IP camera to the Internet; in this case, the camera and the PC
are connected to the LAN ports of a router/switch and the gateway of the camera is set to the IP address of the
router.
4.1

IP CAMERA CONNECTOR LAYOUT (WHERE PRESENT)

1. BNC Interface: Local video signal output.
2. Audio Output Interface: RCA female head (white), can connect with external devices, such as speakers.
3. Audio Input Interface: RCA female head (red), can connect with input devices, such as a microphone.
4. RJ45 Interface (Network Interface): Connector for a RJ45 network cable.
5. Power Interface: DC 12V.
6. Reset Button: The device will restore the default settings if this button is pressed and held for 3 seconds.
7. Alarm Interface: Including alarm input and output interface.
③,④ are alarms input, ① is alarm output, ② is used as GND for Ref. 1099/304
①,② are alarms input, ③ is alarm output, ④ is used as GND for Ref. 1099/202, Ref. 1099/203, Ref.
1099/303.
DS1099-014A 10