Table of Contents
Advertisement
10.4 ALARM
10.4.1
MOTION
Select Motion in the Alarm menu to open the following page:
Motion Detection setting procedure:
1.
Select Enable.
2.
Click and hold the left mouse button and drag out an area for motion detection.
3.
Set the motion detection sensitivity (from 1 to 8; the higher the value, the greater the sensitivity).
4.
Enable Alarm Output, Latch Time (recording time) and Post recoding time.
5.
Enable Send Mail, a function used with SMTP to enable the sending of e-mail.
6.
Select Save to apply the settings.
(Note: When any object moves within the target area, a green letter "M" is displayed in the preview frame).
10.4.2
I/O ALARM:
Select Alarm in the Alarm menu to open the following page:
Alarm Type: Available values: OFF, Normally-Open, Normally-Closed.
Latch Time: Set the alarm output time (5S,10S, 20S, 30S).
Send E-mail, Alarm Output, Enable Recording.
Post Recording: When Enable Record is checked, the recording delay can then be set (5S, 10S, 20S, 30S).
DS1099-014A
28
Advertisement
Table of Contents
