Device Operation Instructions; Check Connection; Searching For The Device - urmet domus 1093 User Manual

Hide thumbs Also See for 1093:

Table of Contents

DEVICE OPERATION INSTRUCTIONS

5.1

The default factory IP address for IP camera is 192.168.1.168 and the subnet mask is 255.255.255.0. Allocate to

your computer an IP address in the same network segment as the IP camera, for example, 192.168.1.69, and a

same subnet mask as that of the IP camera.

Test whether the IP camera is connected properly and started normally by clicking on Start > Run and entering

"cmd" and pressing ENTER, and entering "ping 192.168.1.168" in the command line window to

Check whether the IP camera is accessible. If the PING command is executed successfully, it indicates that the IP

camera operates normally and the network is connected properly. If the PING command fails, check IP address and

gateway setting of the PC and connectivity of the network.

5.2

Feedback: The Device Config Tool function may be used to search for the device across network segments. Before

running the Device Config Tool, select the local connection icon at the bottom right corner of the desktop;

Add the IP addresses of several network segments in the TCP/IP local area connection settings (as shown below).

You can run this tool to search for any device with an IP address in the same network segment.

DS1093-568C

Table of Contents