Programming - NTI ENVIROMUX Series Installation And Operation Manual

NTI Automatic Voice Dialer

PROGRAMMING

The dialer is on standby when only the green power "ON" LED is illuminated. To make changes to the configuration, you must
first enter the four-digit password.
The factory set password is 8888
→ →
ENTER 8888 ENTER
1. Alarm Number
Up to six telephone numbers can be programmed into the dialer.
→ →
Press ENTER 8888 ENTER to get into the menu, you will see:
Note: Setting success will issue "DI" sound.
If there is no operation within 20 seconds, the system will automatically exit and sound "DI~DI~DI~DI"
Menu1-12)
01 Alarm Number
a) Press ENTER Key to start to program the first phone number
b) Press UP and Down Key to select numbers (1-6) you want programmed with ENTER
c) Key in the telephone number and finish by pressing ENTER. Up to 14 digits are allowed.
The number is automatically saved once you hear the sound "DI"
1.1 Delete Telephone number
a) Press ENTER
b) Press UP and Down Key to select the telephone number to be deleted (1-6) and press ENTER
c) Press ENTER again
Setting success will cause the dialer to issue the sound "DI".
2. Record/Play Message
/ PLAY
You can program up to four messages.
Message 0 is used as a location message (common to messages 1, 2 and 3) and lasts up to 12 seconds
Message 1,2 and 3 are used as alarm messages, each lasting up to 6 seconds.
To record or re-record a message:
a) Select the menu with the UP and Down Key.
b) Press ENTER to start recording.
c) Press the number of the message (0-3, where 0 corresponds to the location message).
d) Key in 0= Record, 1=Playback
e) Now speak clearly into the microphone. The countdown (12 seconds for message 0, 6 seconds for message 1-3) is displayed
on the screen.
Example:
A location message (message "0") can be "This is the alarm system at Mr. David's house, Shennan Road, Futian. There is... "
The second part of the message, the alarm message, can be (for example):
Message 1 " Fire alarm "
Message 2 " Personal Attack "
Message 3 " Intruder alarm "
The dialer automatically stops recording at the end of a message delay. If the announcement to be recorded in message 0 is
much shorter than 12 seconds you can stop the recording at any time by pressing ENTER.
After the message is recorded there is a short interval, after which the dialer plays back your recorded message.
6