NTI ENVIROMUX Series Installation And Operation Manual page 11

NTI Automatic Voice Dialer
5. Trigger Modes
The auto dialer has three programmable inputs, and the user can change the trigger mode of the input.
0=Edge Trigger-When the trigger signal is detected the dialer will start dialing. The dialer will make a circular
call to all numbers three times even if the trigger signal is stopped
1=Level Trigger-When the trigger signal is detected the dialer will start dialing. If the trigger signal stops, the
dialer will stop dialing. (Level Trigger is the default setting)
To change the trigger mode
a) Select the menu with the UP and Down keys press 05
b) Key in 0= Edge Trigger, 1= Level Trigger
c) Press ENTER to complete the settings, and then press ESC to return to the menu to continue
6. Display the Latest Event
When the dialer is triggered it will log the trigger input (IP1 to IP3) in its event memory.
To view the last event:
a) Select menu with UP and Down key or press 06 → Enter to start the program
b) The last alarm event will be displayed
c) Press ESC to return to the main menu
Note: If the last alarm number with "OK" is displayed on the screen, it means the user has pressed the "0" key when they
answered the phone and confirmed the alarm notification.
7. Changing the Password
The password is 8888 by default . You can change this as follows:
a) Select the menu with the UP and Down keys or press 07 → ENTER to start the program
b) Press ENTER again to key in new password
c) Press ENTER to complete the settings, and then press ESC to return to the menu to continue. After code is changed, the dialer
automatically resets to the top of the Engineering menu
8. Perform a Test Call
To test that telephone numbers have been set up correctly the dialer can perform a test call. To make a test call:
a) Select the menu with the UP and Down keys or press 08 → ENTER to start the program
b) Press UP and Down key (1 to 6 ) to select the number to be tested.
c) Press ENTER to complete the settings, and then press ESC to return to the menu to continue
9. Setting the Volume
To confirm an action the dialer sounds a fast "DI"
To alert you to an error or exit the program the dialer sounds four DI~DI~DI~DI.
You can alter the volume of these sounds when they are played back. By default the dialer uses Medium (1).
a) Select the menu with the UP and Down keys or press 09 → ENTER to start the program
b) Key in 0 = Mute; 1 = Medium; 2 = Loud
c) Press ENTER to complete the settings, and then press ESC to return to the menu to continue
10. Ring Times
When calling the dialer, after the preset number of ring times you will hear a "beep". Now the user can remotely
activate/deactivate the relay.
a) Select the menu with the UP and Down keys or press 10 → ENTER to start the program
b) Key in 0-9 times, (default is 3)
c) Press ENTER to complete the settings, and then press ESC to return to the menu to continue
→
ENTER to start the program
8