NTI ENVIROMUX Series Installation And Operation Manual page 12

NTI Automatic Voice Dialer
11. Relay Activation Time
The dialer has one relay controlled by the Relay Control Input (IN). The relay activation time can be programmed from 1 to 255
seconds. The factory setting for relay activation time is 10 seconds.
a) Select the menu with the UP and Down keys or press 11 → ENTER to start the program
b) Key in the number (1-255)
c) Press ENTER to complete the settings, and then press ESC to return to the menu to continue
12. Play Times of Recorded Message
When the dialer is triggered it will playback the recorded message ten seconds after the phone is connected with the person
called. The user can set the number of times the recorded message will play, once or twice (default setting is once).
a) Select the menu with the UP and Down keys or press 12 → ENTER to start the program.
b) Key in 1= once; 2= twice
c) Press ENTER to complete the setting, and then press ESC to return to the menu to continue.
13. Answering Alarm Phone Call to Start Remote Control
When an alarm occurs, the auto dialer will call the stored phone numbers. When answering the call, the user will first hear the
recorded voice message and will then have 10 seconds to initiate programming after hearing two beeps. The user can choose the
related instruction to perform remote control operation (see instruction below). If there is no operation within 30 seconds the dialer
will hang up.
Press 1 - to only play the message one time. You will have 10 seconds to begin programming after the message.
Press 2 - to play the message twice. There will be 10 second opportunity to begin programming after each message.
Press 3 - to play the message once more.
Press 4 - to start monitoring. This will turn ON the microphone at the dialer so the caller can hear what is going on in the
environment around the dialer. The call will be one-way, the caller will not be able to talk to anyone at the dialer's location.
Press 0 - to cause the dialer to stop dialing, and it will not dial any other numbers,
You can also call the dialer to control the relay output (whether the dialer has called you or not):
Press 8 - the relay will activate, and the relay will automatically deactivate after the preset time.
Press 9 - to deactivate the relay.
Note: If you call the dialer directly, you will only be able to change the state of the relay. You cannot control the alarm in
any way.
14. Stop dialing through keypad
User can stop the dialer from dialing by using the keypad.
Press Esc → <password> → Enter at the keypad. The dialer will stop dialing in few seconds.
15. Reset
Disconnect the power at the dialer. Press the Enter button and re-apply power to the dialer. It will
issue a long beep which means the dialer has been reset to factory settings.
9