Contec IPC Series User Manual page 38

6. Power Supply Connection
These products can connect the DC power or AC adapter for the power supply.
CAUTION
- Input the power supply to the DC power supply connector only or the AC adapter jack only. Never
supply power to both of them at the same time as it can cause a fault.
- If you connect a power supply other than the optional AC adapter, be sure to take safety measures
for the power supply, such as overvoltage protection. Use meticulous care not to mistake the
connection polarity or voltage of the power supply as it may break the equipment, the power supply,
or both.
- When power cycling, wait for more than ten seconds before use.
DC Power Supply Input Connector : DC-IN
When connecting the power supply, ensure that the supply satisfies the specifications below.
Power supply voltage
Power supply capacity
Please process it as shown in the table below by using an attached housing and contact. Then connect it.
Table 6.1. DC power supply connector
Connector type
4 3
2 1
Applicable connector of cable side
Housing : 9357-04 (mfd. by ALEX) or 5557-04R (mfd. by MOLEX)
Contact : 4256T2-LF (mfd. by ALEX) or 5556 (mfd. by MOLEX)
Cable : AWG#18 - 24
Crimp tool : 57026-5000 (UL1007) (mfd. by MOLEX), 57027-5000(UL1015) (mfd. by MOLEX)
Rise time of power supply
Voltage
1 - 30mS
12V
Figure 6.1. Graph of Rise Time of Power Supply
FPD-M75VT-DC1, FPD-L75ST-DC1, FPD-H75XT-DC1
: 12 - 24VDC±5%
: 12V 3A or more, 24V 1.5A or more
9360-04P (mfd. by ALEX)
Pin No. Signal name
1 GND
2 GND
3 12 - 24V
4 12 - 24V
Time
6. Power Supply Connection
33