Contec IPC Series User Manual page 34

CAUTION
- Do not connect it with the DVI-D at the same time. Doing so may provide abnormal screen display.
- DOS prompt may fail to display the full screen depending on the PC for connection . In such a case,
you can display it by changing the display driver setting to the one of the followings.
1. Select the "Intel(R) Dual Display Clone" and change the primary device to the notebook.
2. Select the "twin" on the multiple display setting.
3. Select the "Notebook" on the single display setting.
Note that the above setting is used when the "Intel Extreme Graphics2" is used. The setting item
may be quite different and depend on the other driver and version.
- Depending on the following IPC Series or SBC, you may fail to set the VGA (640 x 480) in the
resolution. In such a case, it is required to update the BIOS, so please contact your retailer.
IPC Series : IPC-BX701 Series, IPC-BX900 Series
SBC : SEH-9450-LAS, SPC-9450-LA, SPI-845x-LLVA, SLC-85xx-LxA
FPD-M75VT-DC1, FPD-L75ST-DC1, FPD-H75XT-DC1
4. Hardware Setup
29