Contec IPC Series User Manual page 30

5. Connection to the Host Computer
Purchase individual connection cables as they are not bundled with this equipment.
LVDS Interface Connection
These products can be connected to CONTEC host computer (IPC Series and single board computer
(SBC)) that have LVDS display output. Connect the LVDS connector of supported host computer with
these products using the dedicated LVDS connecting cable.
As for the specific IPC Series or SBC, you need to change the BIOS setting to display it appropriately by
the LVDS input. For more details on this, refer to the manual for each HOST computer.
When connecting to a SBC
LVDS conversion bracket and LVDS cable are required (separately available).
Be sure to connect a conversion cable that supports each LVDS output pin header, and then connect the
LVDS connector of the cable with these products using a LVDS cable.
Depending on the SBC, two or more LVDS output pin headers are equipped. Be sure to check the
connector reference No. of conversion cable and each SBC. Then connect it to the appropriate
connector.
Conversion cable
FPD-30F26F
FPD-20F26F
WARNING
When using the SLC-85xx-LxA, SPC-9450-LAS or SEH-9450-LAS. Be sure to connect
FPD-30F26F to the 30 pin LVDS output pin header connector before use. These SBC which have
20pin LVDS output pin header, be sure to use not the FPD-20F26F but the FPD-30F26F.
CAUTION
Connecting FPD-M75VT-DC1 and SPC-852x-LA is not supported.
FPD-M75VT-DC1, FPD-L75ST-DC1, FPD-H75XT-DC1
SBC
SEH-9450-LAS
SPC-9450-LA
SPC-852x-LA
SLC-85xx-LxA
SPI-855x-LLVAS
SPI-8550-LA
SPI-845x-LLVA
Reference
LVDS1
LVDS1
CNK1
CN15
CN18
CN18
CN12
4. Hardware Setup
25