Contec IPC Series User Manual page 37

4. Hardware Setup
- When connecting to BOX-PC
Note that the following IPC series products do not have the RS-232C in the DVI-D interface so the touch
panel must be connected via USB.
- IPC-BX950TxD series (DVI-D interface)
For more details on the allocation to RS-232C port No. in the LVDS/DVI-D connector, refer to the
manual for each PC.
CAUTION
- Touch panel driver software is required to use the touch panel. Purchase optional driver software
[IPC-SLIB-01 for windows or IPC-TPB1-DRV for Windows] or download one from the
CONTEC's web site.
- The USB touch panel driver software requires Ver1.52 or later of IPC-SLIB-01.
- The USB connection can only be used on Windows XP, 2000, or 98SE. Connect via the RS-232C
interface if using a different OS.
- Use either USB or RS-232C for connecting the touch panel. The touch panel cannot be connected
via both interfaces at the same time.
- When using the USB connection, the screen image may disappear momentarily when the USB cable
is connected or disconnected and when the computer power is turned ON or OFF.
- When using the USB connection via a hub, the unit may not operate correctly in some cases
depending on the other USB devices connected to the hub. Please check the operation before using
in practice.
- If you connect these products to the SBC products which have the 20-pin LVDS output pin header,
use the touch panel via the USB connection because RS-232C signal line is not included in the
LVDS interface.
32
FPD-M75VT-DC1, FPD-L75ST-DC1, FPD-H75XT-DC1