I/O Equipment Installation; Dc In; Serial Com Port; External Hdmi - Winmate IK32 User Manual

USER MANUAL CHAPTER 2 HARDWARE INSTALLATION

2.3 I/O Equipment Installation

2.3.1 12V DC in
The IK32 Motherboard allows plugging 12V DC-IN jack on the board without another
power module converter under power consumption by Intel® 7th Generation Core i5
Processor.

2.3.2 Serial COM Port

Three RS-232 connectors build-in the rear I/O. One optional COM port supports
RS-422/ 485. When an optional touch-screen ordered with PPC, serial COM port
can be connected to a serial or an optional touch-screen. You can change serial
COM port setting through BIOS.

2.3.3 External HDMI

The Motherboard has one HDMI port that can be connected to an external LCD
monitor by HDMI cable, and it also needs to be connected to the outlet by power
cable. The HDMI connector is a standard 19-pin Type A connector.

2.3.4 Ethernet Interface

The Motherboard is equipped with Intel® I211-AT Gigabit-LAN Controller + I219-LM
Gigabit-LAN PHY which is fully compliant with the PCI 10/100/1000 Mbps Ethernet
protocol compatible. It is supported by major network operating systems. The
Ethernet ports provide two standard RJ-45 jacks.

2.3.6 USB Ports

Six USB devices (four with pin headers) can be connected to the system through an
adapter cable. Various adapters may come with USB ports. USB usually connected
the external system. The USB ports support hot plug-in connection. Whatever, you
should install the device driver before you use the device.

2.3.7 Audio

The Audio 7.1 channel capabilities are provided by a Realtek ALC283 chipset
supporting digital audio outputs. The audio interface includes three jacks: line-in,
line-out and mic-in
- 27 -