Kernau KBH 07551 X3 Manual Instruction page 20

• The hood should never be used as a support surface, unless such possibility
has been clearly indicated.
• The kitchen hood is used to remove kitchen vapors outside, it should
be connected to adequate ventilation duct (do not connect it to chimney,
smoke, flue ducts in use).
• If, in addition to the hood, other non-electric devices are used in the room
(e.g. liquid fuel stoves, flow heaters, thermostats), sufficient ventilation
should be ensured.
• Unplug the appliance from the socket before each cleaning operation,
filter change or before carrying out any repair work.
• Do not connect the device to the mains before completing assembly.
• All assembly and maintenance operations should be carried out using
protective gloves.
• Before connecting the hood to the mains power supply and checking
its proper operation, always check that the power cable has been correctly
installed and that it has not been crushed by the hood during installation.
• Never use the hood without properly installed filters.
• To the range necessary for the application of technical and safety
measures regarding the discharge of flue gases, the regulations issued
by the competent local authorities must be strictly observed.
• The kitchen hood should be cleaned inside and outside (min once at month,
according with maintenance tips given in these manual), overheated
fat is flammable.
• Under the kitchen hood do not leave the open fire. Set the minimum
flame when removing dishes form the burner.
• The use of open fire is dangerous to filters and creates the risk of fire,
so do not under any circumstances. When frying, be careful not to
overheat the oil so that it does not ignite. Available parts can become
very hot if used together with cooking appliances.
• Damaged the power cord should be replaced with special cord avaiable
at manufacturer or specialist repair shop.
• The vapors cannot be discharged in the chimney duct used to remove flue
gas form appliances burning gas or other fules ( do not apply to closed
circulation).
• If the cleaning process is not carried out according to the instructions,
there is a risk of fire.
EN
19