Using The Remote; Programming The Remote - Sony STR-DN2010 Operating Instructions Manual

Presetting satellite radio
channels
(USA model only)
1
Select a channel you want to
preset.
For details on this operation, see
"Selecting channels from a category
(CATEGORY TUNING)" (page 129).
2
Press SHIFT, then press
MEMORY.
"MEM" lights up on the display.
3
Press PRESET + or PRESET –
to select a preset number.
You can also select the number by
pressing SHIFT, then numeric buttons.
Preset numbers from 1 to 30 are available.
Channel 1 is initial setting for the preset
numbers when you purchase the receiver.
4
Press ENTER.
If SHIFT indicator is light off before you
press ENTER, press SHIFT.
"MEM" lights off.
5
Repeat steps 1 to 4 to preset
another channel.
Selecting a preset channel
1
Press TUNER repeatedly to select
"SIRIUS".
2
Press PRESET + or PRESET –
repeatedly to select the preset channel
you want.
You can also press SHIFT, then numeric
buttons to select the preset channel you
want. Then, press
GB
130
to enter the selection.

Using the Remote

Programming the remote

You can customize the remote to match the
components connected to your receiver. You
can even program the remote to control non-
Sony components and also Sony components
that the remote is normally unable to control.
Before you begin, note that:
– You cannot change the settings of TUNER
and DMPORT input buttons.
– The remote can control only components
that accept infrared wireless control signals.
Be sure to turn on the receiver and
point the remote towards the
receiver when performing the
following procedure.
RM
SET UP
SHIFT
Input
buttons
1
Press and hold RM SET UP,
then press AV ?/1.
The RM SET UP indicator flashes slowly.
2
Press the input button for the
component you want to control.
For example, if you are going to control a
VCR connected to VIDEO 1 jacks, press
VIDEO 1.
The RM SET UP and SHIFT indicator
light up.
AV ?/1
TV
Numeric
buttons
ENTER