Sony STR-DN2010 Operating Instructions Manual page 45

3
Press V/v repeatedly to select
"Auto Calibration", then press
.
4
Press V/v repeatedly to select
"Calibration Start", then press
.
The screen on which you can select the
item to be measured appears.
5
Press V/v repeatedly and
uncheck the items you do not
want to measure, then press b.
The confirmation screen, asking whether
you are ready to start measurement,
appears.
6
Press to select "Start".
The measurement starts in five seconds.
The measurement process will take
approximately 30 seconds with a test
tone. Wait until the measurement process
completes.
When the measurement ends, a beep
sounds and the screen switches.
Note
If an error code appears on the screen, see
"Message list after Auto Calibration
measurement" (page 48).
7
Press V/v repeatedly to select
the item you want, then press
.
Item and explanation
Retry
to
Performs the Auto Calibration again.
Save
Saves the measurement results and exits the
setting process (page 46).
Warning
Displays warning concerning the
measurement results. See "Message list after
Auto Calibration measurement" (page 48).
Phase*
Displays the phase of each speaker (in phase/
out of phase).
Distance
Displays the measurement result for speaker
distance.
Level
Displays the measurement result for speaker
level.
Exit
Exits the setting process without saving the
measurement results.
To save the measurement results, follow
the steps in "3: Saving the measurement
results" (page 46).
If you want to check error code or
warning message, see "Message list after
Auto Calibration measurement"
(page 48).
continued
GB
45