Inserting Batteries Into The Remote; Step 1: Speaker System Hookup - Sony AVD-S10 Operating Instructions Manual

Super audio cd/dvd receiver

Hide thumbs Also See for AVD-S10:

Table of Contents

Inserting Batteries into the Remote

You can control the receiver using the supplied remote. Insert two R6 (size AA) batteries by

matching the 3 and # ends on the batteries to the markings inside the compartment. When

using the remote, point it at the remote sensor

Notes

• Do not leave the remote in an extremely hot or humid place.

• Do not use a new battery with an old one.

• Do not drop any foreign object into the remote casing, particularly when replacing the batteries.

• Do not expose the remote sensor to direct light from the sun or lighting apparatus. Doing so may cause a

malfunction.

• If you do not use the remote for an extended period of time, remove the batteries to avoid possible damage from

battery leakage and corrosion.

You can enjoy surround sound by connecting 5 speakers (front L/R speakers, centre speaker,

rear L/R speakers) and active subwoofer to the receiver. If you do not connect 5 speakers and

active subwoofer to the receiver, the receiver optimizes the surround signal depending on the

number of connected speakers. When you connect 2 speakers to the receiver, connect the

speakers to the SPEAKERS FRONT L/R jacks.

Notes

• Be sure to match the speaker cord to the appropriate terminal: 3 to 3, # to #, L to L, and R to R jack.

• Use the high performance speakers.

• Use the same size and performance speakers for the front, centre, and rear speakers.

• To obtain the best possible surround sound, specify the speaker parameters (number, distance, level, etc.) on page

23.

on the receiver.

Table of Contents