Hdmi Settings Menu - Sony STR-DN2010 Operating Instructions Manual

HDMI Settings menu

You can make the required settings for
components connected to the HDMI jack.
Control for HDMI
Lets you turn the Control for HDMI function
on or off. For details, see "Preparing for the
"BRAVIA" Sync" (page 90).
x ON
x OFF
Note
When you set "Control for HDMI" to "ON", "Audio
Out" may be changed automatically.
Pass Through
Lets you output the HDMI signals to the TV
even when the receiver is in standby mode.
x OFF
The receiver does not output HDMI signals
when the receiver is in the standby mode.
Turn on the receiver to enjoy the connected
component's source on the TV. This setting
saves power in the standby mode compared
with the "ON" setting.
x AUTO
When the TV is turned on while the receiver is
in the standby mode, the receiver outputs
HDMI signals from the receiver's HDMI TV
OUT jack. Sony recommends this setting if
you use a TV that is compatible with
"BRAVIA" Sync. This setting saves power in
the standby mode compared with the "ON"
setting.
x ON
When the receiver is in the standby mode, the
receiver continuously outputs HDMI signals
from the receiver's HDMI TV OUT jack.
Notes
• This parameter is not available when "Control for
HDMI" is set to "OFF".
• When "AUTO" is selected, it may take a little more
time for the image and sound to be output to the TV
than when "ON" is selected.
• When the receiver is in standby mode,
"A. STANDBY" appears on the display if "Pass
Through" is set to "AUTO" or "ON". However,
"A. STANDBY" will disappear when "Pass
Through" is set to "AUTO" and no signals are
detected.
Audio Out
Lets you set the HDMI audio signals from the
playback component connected to the receiver
via an HDMI connection.
x TV+AMP
The sound is output from TV's speaker and the
speakers connected to the receiver.
Notes
• The sound quality of the playback component
depends on the TV's sound quality, such as the
number of channels, and the sampling frequency,
etc. When the TV has stereo speakers, the sound
output from the receiver is also stereo as that of the
TV, even if you play back multi channel source.
• When you connect the receiver to an image display
component (projector, etc.), sound may not be
output from the receiver. In this case, select
"AMP".
• When you select the input that you have assigned
the HDMI input, sound does not output from the
TV.
x AMP
The HDMI audio signals from the playback
component is only output to the speakers
connected to the receiver. Multi channel sound
can be played back as it is.
Note
Audio signals are not output from the TV's speaker
when "Audio Out" is set to "AMP".
GB
117