Sony STR-DN2010 Operating Instructions Manual page 47

Checking the Auto Calibration
results
To check error code or warning message
obtained in "2: Performing Auto Calibration"
(page 44), proceed with the following steps.
Press V/v to select "Warning" in
step 7 in "2: Performing Auto
Calibration" (page 45) then press
.
If a warning message appears, check the
message and use the receiver without change.
Or if necessary, perform Auto Calibration
again.
When "Error Code" appears
Check the error and perform Auto Calibration
again.
1
Press to select "Enter".
"Retry?" appears on the TV screen.
2
Press B/b to select "Yes", then press
.
3
Repeat steps 6 to 7 in "2: Performing
Auto Calibration" (page 45).
To save measurement results
that caused an error without
taking a remedy
1
Press V/v repeatedly to select "Save" in step
7 in "2: Performing Auto Calibration"
(page 45), then press
2
Follow the steps in "3: Saving the
measurement results" (page 46) to save the
measurement results.
.
continued
GB
47