Table of Contents
Advertisement
Item
Optical fiber
Antenna
Ground cable
2.2
Installation Tool
Knife
Tape measure
NOTE: Other accessories have been packed in the packing box.
2.3
Install GPS Antenna
Read the following GPS antenna installation requirements before installing it on the eNB.
No major blocking from buildings in the vicinity. Make sure the space atop is at least
45 degrees unblocked by any buildings.
Avoid installing the GPS antenna in the vicinity of any other transmitting and
receiving devices, to avoid interference.
The GPS antenna should be installed within 45 degrees to the lightning rod.
The GPS antenna system is assembled in manufacturing before packing. The only
installation step is to fix the GPS mounting bracket on the eNB with the M4*14 screws
(Figure 2-1).
Figure 2-1 GPS Antenna Installation
Single mode optical fiber
Omnidirectional, or directional antenna
The diameter of grounding cable must be 10mm
Vise
Percussion drill and
some drill heads
8
Description
Wrench
Cross screw driver
Cable vice
2
or greater.
hammer
Advertisement
Table of Contents
