Table of Contents
Advertisement
Assembly Instructions
Assembly Instructions
13�6 Attaching scrapers to the M 5000 scraper holder,
assembly from below
Retaining lock nut
Reinforcing sheet metal
(black plate)
from 160 mm wigth: large
Reinforcing sheet
Scraper
CAUTION: beveled side below!
Holding plate with pressed-in
screws
Mounting devices 1x Holding plate, 1x Reinforcing sheet metal, 2x Retaining lock nut
Insert the holding
Push the scraper
plate from below
on to the threaded
through the scraper
holder.
13�7 Assembling the cone holder in the conical receiver
Subject to change without notice
54
Push the large
reinforcement plate
(160 scraper and above) on
pins.
to the threaded pins.
1. Insert the cone holder into the chisel holder.
2. Insert the cone holder into the chisel receiver.
3. Align the cone position with the T-handle
4. Put the VOGT compressed air equipment into ope-
ration (see Sections 3 and 4).
5. Let the equipment run briefly, the cone holder will
drive itself in automatically
VH / VTS / VBL / VAI Translation of the original operating manual
Scraper must rest
Scraper holder M 5000 / M 5000.18
on the edge
902 020
Push the small
Screw on the wedge
reinforcement plate
securing nuts by
(black plate) on to
hand.
the threaded plate.
Mounted:
Fertig montiert:
Scraper till 120 mm
Fertig montiert:
Schaber mit
Schaber
Umlenkvorrichtung
Scraper from 160 mm
Tighten with a
wrench.
US edition 2021/01
Contact:
+49(0)92 78-774 33-0
+49(0)92 78-774 33-11
www.vogt-tec.com
Advertisement
Table of Contents
