Attaching Scrapers To The M 5000 / M 5000.18 Scraper Holder; Assembly From Below; Assembling The Cone Holder In The Conical Receiver - Vogt WorkTec VH10 Translation Of The Original Operating Manual

Assembly Instructions
13�6 Attaching scrapers to the M 5000 scraper holder,

assembly from below

Retaining lock nut
Reinforcing sheet metal
(black plate)
from 160 mm wigth: large
Reinforcing sheet
Scraper
CAUTION: beveled side below!
Holding plate with pressed-in
screws
Mounting devices 1x Holding plate, 1x Reinforcing sheet metal, 2x Retaining lock nut
Insert the holding Push the scraper
plate from below on to the threaded
through the scraper
holder.
13�7 Assembling the cone holder in the conical receiver
Subject to change without notice
56
Push the large
reinforcement plate
(160 scraper and above) on
pins.
to the threaded pins.
1. Insert the cone holder into the chisel holder.
2. Insert the cone holder into the chisel receiver.
3. Align the cone position with the T-handle
4. Put the VOGT compressed air equipment into ope-
ration (see Sections 3 and 4).
5. Let the equipment run briefly, the cone holder will
drive itself in automatically
VH / VTS / VBL / VAI Translation of the original operating manual
Scraper must rest Scraper holder M 5000 / M 5000.18
on the edge
902 020
Push the small Tighten retaining lock
reinforcement plate nuts by hand
(black plate) on to
the threaded plate.
YouTube Manual: mount / loosen
cone holder
Mounted:
Scraper till 120 mm
Fertig montiert:
Fertig montiert:
Scraper from 160 mm
Schaber mit
Schaber
Umlenkvorrichtung
180°
Tighten with defined angle.
New nuts: 180°
Reused nuts: 100°
or tightening torque 52 nm
US edition 2021/10
Contact:
+49(0)92 78-774 33-0
+49(0)92 78-774 33-11
www.vogt-tec.com