Table of Contents
Advertisement
Help in the event of faults
Fault
Possible cause
Dirt has gotten in via
the air hose.
Excessive pressing
force.
Tool no longer
Tool or tool hold-
slots into the
er knocked out of
tool holder or
place (usually due to
does not stay in
excessive operating
place in the tool
pressure or operat-
holder.
ing the device when
it is not in contact
with any material).
Tool cannot
The clamping sleeve
be inserted or
on the tool holder
removed.
is being pushed all
the way back rather
than halfway when
the tool is inserted
or removed.
Dirt inside the
clamping sleeve is
preventing unlock-
ing.
The com-
The spring on the
pressed air
trigger lever has
device operates
broken, or the
continuously
O-ring on the trigger
even though the
valve has come
trigger lever is
away from the
not being actu-
valve seat or been
ated.
cracked due to ex-
cessive pressure.
Subject to change without notice
34
How to fix
The manufacturer or an authorized specialist work-
„
shop will need to carry out repairs or cleaning.
Lubricate the chisel holder and reduce the pressing
„
force.
Check the tool for wear (see Chapter 3.4, "During
„
operation").
The manufacturer or an authorized specialist work-
„
shop will need to carry out repairs.
Only push the clamping sleeve on the tool holder
„
halfway back when inserting or removing the tool.
The manufacturer or an authorized specialist work-
„
shop will need to carry out repairs or cleaning.
The manufacturer or an authorized specialist work-
„
shop will need to carry out repairs.
VH / VTS / VBL / VAI Translation of the original operating manual
US edition 2021/01
Contact:
+49(0)92 78-774 33-0
+49(0)92 78-774 33-11
www.vogt-tec.com
Advertisement
Table of Contents
