Table of Contents
Advertisement
Getting ready for operation
Choosing the operating pressure
Subject to change without notice
24
1. Insert an in-line oiler (Z 300) into the compressed air line if one is not
already integrated into the compressed air supply. Observe the follow-
ing basic points:
The in-line oiler should be inserted between the final compressed
−
air hose and the previous hose or, as appropriate, the compressor.
−
The in-line oiler cannot be more than 10 meters away from the
compressed air device.
−
The oiler must always be on the same floor as or level with the
equipment.
2. Connect the compressed air hose to the compressed air supply (e.g. a
compressor) and open the compressed air infeed if an additional stop
cock has been fitted.
3. Check that the hoses and couplings are leak-tight. If they are not,
switch off the compressed air supply and replace the hose immediate-
ly.
4. Connect the compressed air hose to the connecting hose on the VOGT
compressed air device.
The VOGT Hammer / TurboSpade may start up
unintentionally�
Risk of severe injury.
¾ Position the device so that the tool is not pointing
¾ If the device starts up by itself, disconnect the
¾ Shut the device down and send it to the manu-
Different levels of working pressure are recommended for materials that
are to be worked in different ways. As a general principle, the lower the
material's resistance, the lower the recommended operating pressure.
Excessive pressure increases vibrations, impairs performance, and causes
damage to the VOGT compressed air device and tool.
See the following table for recommendations:
VH / VTS / VBL / VAI Translation of the original operating manual
Risk of tripping over carelessly laid hose
lines�
Danger of injury.
¾ Make sure that the hose line has not been
laid across any roads or paths and is lying
flat on the ground.
¾ Ensure that there is adequate spare hose
in the working area.
at any people or animals.
compressed air supply immediately.
facturer or an authorized specialist workshop for
repairs.
US edition 2021/01
Contact:
+49(0)92 78-774 33-0
+49(0)92 78-774 33-11
www.vogt-tec.com
Advertisement
Table of Contents
