Table of Contents
Advertisement
7.5.1.1 Alarm
If "Alarm" is selected, we have access to program the flow rate at which the relays will
change its status and to the level of hysteresis. By level of hysteresis we understand the
difference between activation and deactivation of the output. To avoid that an alarm output
is continuously moving from activate to deactivate status, we must program the points of
connection and disconnection.
Example
If the activation point is programmed to 100 m
to 90 m
3
/h, when the flow rate is zero the output will be deactivated. When the flow rate
reaches a value of 100 m
m
/ h.
3
If we program an activation point of 90 m
flow rate is zero the output will be activated. When the flow rate reaches a value of 100 m
the output will be deactivated until the flow rate falls below 90 m
7.5.1.2 Empty pipe
In this case, the relay will change its status when the flowmeter detects empty pipe.
7.5.1.3 Negative flow
The relay will change its status when the flow rate changes its sign.
7.5.2
Pulse output
This output allows to connect the converter to a PLC or remote totalizer. The number of
pulses per unit of volume can be programmed. The following parameters can be selected.
7.5.2.1 Pulse output configuration
It allows to choose between unidirectional and bidirectional.
3
/h and the deactivation point is programmed
/h the output will be activated until the flow rate falls below 90
3
3
/h and a deactivation point of 100 m
38
3
/h, when the
3
/h.
3
/h
Advertisement
Table of Contents
