Cable Connection To Converter - Tecfluid FLOMID Series Instruction Manual

•
Slide the cover on the sensor neck until it meets its stop.
•
Tighten the two fixing screws to anchor the cover.
•
Tighten the cable gland to guarantee water tightness.
3.4

Cable connection to converter

So that the flow direction shown in the instrument matches the actual direction, please take
into account the cables colour scheme according to the figure on page 21.
Terminal
16 Top coil (red cable)
17 Bottom coil (black cable)
18 Rear electrode (white cable)
19 Ground (shield)
20 Front electrode (black cable)
24