Table of Contents
Advertisement
7.2
Units
In this screen the units for the liquid velocity, the flow rate and the totalizer can be chosen
independently.
7.3
Flow rate decimals
In this screen the number of decimals for the flow rate indication can be selected.
To select the number of decimals it must be taken into account that the instrument has 5
digits for flow rate indication. If two decimals have been selected, these will be seen whilst
the flow rate is not higher than 999.99. Above this value the indication will automatically
change to one decimal, and when the flow rate is higher than 9999.9 the indication will be
done without decimals.
If one decimal is selected, the flow rate indication will have a maximum of one decimal until
9999.9. Above this value the indication will be done without decimals.
If indication without decimals is selected, the flow rate will always be shown without
decimals.
For the selection of the flow rate units and the number of decimals it must be taken into
account that an indication with an excess of decimals may give the sensation of instability of
the reading. As a general rule it can be considered that the reading should not have more
than a total of 5 digits (integer + decimals).
34
Advertisement
Table of Contents
