Dyson DC15 Service Manual page 45

Cyclone and bin assemblies
198
Firmly pull the FDC seal off the base of the
cyclone assembly.
When refitting the FDC seal ensure the top of
the seal covers all the ribs on the base of the
cyclone assembly.
199
Prise the bin base assembly away from the
base of the bin until it detaches.
200
To refit the bin base assembly, position one
of the locating tabs into one side of the retainer.
Then press the other side firmly until it clips into
position.
Issued 05/05
Assembling the duct assembly
201
Fit the spring onto the cruciform on the
cyclone release catch. Clip one leg of the
catch into the retainer on the duct. Twist the
other leg into the duct.
202
Align the sides of the lower cable winder
with the channels on the inside of the duct.
Slide onto the duct until the release catches
lock into place.
203
Refit the duct/valve seal onto the side of
the duct. Note: the side with the ridge faces
outwards.
service manual
42