Dyson DC15 Service Manual page 18

service manual
48
Turn the brush housing over and locate the
motor into the brushbar motor front mount.
49
Lower the brushbar motor assembly onto
the brushbar motor bottom mounts. Attach
both yoke loom wires onto the end of the
brushbar motor.
50
Locate the end of the outer insulation
sheathing behind the wall as shown.
15
51
Push the yoke loom grommet into the locator
in the brush housing. Locate the grommet onto
the brushbar motor assembly. Press the sheaving
into the channel on the brush housing.
52
Refit both brushbar motor top mounts into
the brushbar motor cover assembly.
53
Refit the cleanerhead spring onto the cruciform
on the brush housing. Lower the brushbar motor
cover assembly over the yoke loom.
Issued 05/05