Dyson DC15 Service Manual page 40

service manual
169
Attach the red wire to the remaining
terminal on the brushbar switch. Dress all
wires neatly within the locators on the duct.
170
Align the base of the switch cover with the
locators on the duct. Once located lower the
cover onto the duct.
171
Refit both switch buttons into the top of the
duct. Clip the switch cover in place. Refit the
three screws in the rear of the duct.
37
Removing and refitting the internal
cable
172
Remove the duct cover and duct seal from
the side of the duct. Carefully slide the PCB out
of the duct.
173
Carefully detach the three wires from the top
of the PCB. Detach the internal cable from the
vac motor loom. Carefully snip the cable tie.
174
Remove the switch cover. Detach the internal
cable from the switches at the top of the duct.
Remove the internal cable from the duct.
Issued 05/05