Dyson DC15 Service Manual page 32

service manual
125
Push the side of the stabiliser out the rear
of the valve assembly.
126
Release the other side of the stabiliser
from the base of the duct.
29
Refitting the stabiliser
127
Locate the end of the stabiliser into the base
of the duct.
128
Align the detail on the other end of the
stabiliser with the rear of the spring mount
assembly. Slide into place. Refit the screw and
washer.
129
Slide the end of the static cover under the
yoke spigot, then refit the screw.
Issued 05/05