Dyson DC15 Service Manual page 12

service manual
15
Prise the other end of the gimble lock arm
assembly out of the yoke using a thin flat
bladed screwdriver, ensuring that you retain the
gimble lock arm spring.
16
Carefully remove the actuator arm spring
from the gimble lock arm using a thin flat
bladed screwdriver.
9
gimble lock arm spring
Dismantling the cleanerhead
17
Undo the two fasteners on the rear of the
end cap assemblies.
18
Untwist both end cap assemblies and pull
from the side of the brush housing.
19
Pull both halves of the brushbar assembly
out of the brush housing.
Issued 05/05