Dyson DC15 Service Manual page 29

Refitting the motor bucket and ball
109
Align the screw bosses on the rear of the
motor bucket seal/loom assembly with the
locators in the base of the duct.
110
Place the wires from the motor bucket
seal/loom assembly through the large hole in the
side of the duct. Locate the motor bucket axle
into the hole in the valve assembly.
Issued 05/05
111
Push the rear of the motor bucket into the
side of the duct. Refit the two screws.
112
Lower one half of the ball assembly onto
the large and small bearings. Repeat for the
other side. Snap together and refit the four
screws.
113
Dress the looms neatly in the side of the
duct and fix in place with 3 cable ties.
I I m m p p o o r r t t a a n n t t : : ensure the upright switch loom is
located under the screw boss.
service manual
26