Dyson DC15 Service Manual page 38

service manual
158
Refit the moving cover onto the rear
spring. Refit the rear spring onto the retaining
peg on the rear of the valve assembly.
159
Refit both locators on the moving cover
onto the retaining pegs on the rear of the
valve assembly.
160
Refit the static cover onto the base of the
valve pipe. Refit the screw.
T T h h e e f f o o l l l l o o w w i i n n g g p p a a r r t t s s s s h h o o u u l l d d t t h h e e n n b b e e
r r e e f f i i t t t t e e d d a a s s p p r r e e v v i i o o u u s s l l y y s s h h o o w w n n : :
m m o o t t o o r r b b u u c c k k e e t t a a n n d d b b a a l l l l , , ( ( p p a a g g e e s s 2 2 6 6 - - 2 2 7 7 ) )
c c l l e e a a n n e e r r h h e e a a d d a a n n d d y y o o k k e e , , ( ( p p a a g g e e s s 1 1 9 9 - - 2 2 0 0 ) )
35
Removing the powercord assembly
and switches
Switch cover
release catch
161
Remove the wand handle from the top of
the duct. Undo the three screws in the rear of
the duct. Gently push the switch cover release
catch using a torx screwdriver.
162
Pull the switch cover off the front of the
product. Lift out both of the switch buttons.
163
Carefully remove all wires from both switches.
Issued 05/05