Dyson DC15 Service Manual page 34

service manual
134
Slide another washer, the second stabiliser
wheel and then the last washer onto the end of
the stabiliser axle. Carefully refit the circlip.
135
Refit the axlestand spring onto the hook
in the axlestand in the direction shown. Then
carefully refit both legs into the holes in the
stabiliser.
136
Firmly push the top of the axle stand into
the channel on the rear of the duct.
31
Removing and dismantling the
valve cuff and valve seal
137
Press the cyclone release catch to remove
the cyclone and bin assembly from the product.
138
Press the release catch inwards and remove
the valve pipe from the valve assembly.
139
Locate a thin flat bladed screwdriver into the
channel below the duct valve seal.
Issued 05/05